FlyColor X-Cross BL32 50A ESC (3-6S)
MAJOR SELLING POINTS
- ARM 32-bit Cortex MCU with BLHeli_32 firmware，which is faster than BLHeli_S；
- Dshot signal is supported at any rate up to Dshot1200；
- Adopting top quality MOSFET，low resistance，excellent impulse stability；
- Aluminum heat sink effectively slow down the temperature rise.；
- Full contact soldering pad，more stable soldering.
- ARM 32-bit Cortex MCU, frequency up to 48 MHZ.
- BLHeli_32 firmware，which is designed for superior functionality and performance.
- Supports regular 1-2ms pulse width input, as well as Oneshot125 (125-250us), Oneshot42 (41.7-83.3us) and Multshot (5- 25us). The input signal is automatically detected by the ESC upon power up.
- Dshot signal is supported at any rate up to at least Dshot1200.
- Damped light does regenerative braking, causing very fast motor retardation, and inherently also does active freewheeling.
- Supports higher KV motor and more power load, more suitable for violent flight of racing drone .
- The silicone twisted-pair of the throttle signal cable effectively reduces the crosstalk caused by signal transmission, and makes flight more stable.
- Aluminum heat sink effectively slow down the temperature rise.
- Con. Current：50A
- Burst Current (10S)：60A
- LiPo cells：3-6S
- Typical Applications：170-450mm Multi
X-CROSS BL-32 IS USING FLYCOLOR_X_CROSS_BL_32_MULTI FIRMWARE.
AMP DRAW DEMO
In this demo, flycolor was able to draw 71A with the ESC before the motor dies and ESC remains alive.